Please give me a price for this product in lots of, 50, 100, 200
The front section is printed in colour with white overprint on reverse of pvs .35mm thick clear pvc. Also give me a price on thicker pvc as well. About .7 mm.
The image below shows the artwork sample for the wheel.
The wheel is die cut into a circle 290.5 mm Diameter – with a 4 mm Diameter central hole and the rectangle section to the right of the wheel is also cut out. I have coloured the cutout sections in red.
The white boxes in the wheel are unprinted and are clear so you can see through them to the background sheet.
I will supply artwork for the job when i get a good quote.
The Red rectangle section which will be cut out with the die is rotated so that the user can see the 12 green-lined boxes on the rear sheet. And the user writes his selection of lotto numbers in those boxes on the rear sheet.
The Die for the front wheel is below:
The rear section is printed in colour both sides on .35mm thick white pvc. Also give me a price on thicker pvc as well.
Below is the front side of the rear wheel.
The reverse of the rear wheel artwork is below:
The die for the rear wheel is below:
The wheels are attached with an eyelet with a 4 mm shaft – firm enough so the wheels can be rotated but not loose. These wheels are to be attached with the eyelets in-house.
An example of the eyelet attaching the wheels is below:
Can you also give me a separate price for packaging each unit in sealed plastic sleeve, ready for retail display.